With the Fixturlaser PAT, you are never in doubt on whether your belt transmissions are aligned or not. By using the groove as reference, you will achieve a precise alignment which reduces belt wear, bearing failures and vibrations.
The Fixturlaser PAT comes with two line laser transmitters, each equipped with two spring loaded guides which fit into the pulley grooves. The Fixturlaser PAT is equipped with various sized removable guides to fit standard sheave sizes A-E (6 mm - 40 mm). Additional guides for alignment of timing belts are avilable as accessories.
The use of two laser transmitters with integrated targets, makes it very easy to find out what kind of alignment that is required. Parallel offset, angular error and twist are instantly visible to the operator. Within a few minutes, the operator can determine if the machine requires alignment or not.
The alignment process is as easy as the mounting. Just turn on the lasers and look at the opposite mounted unit. The laser draws a line on the target label as in the illustration above. If necessary, adjust your machine position until the laser lines are aligned with the centre mark on both units.
Technical Specification*
|
| Housing material |
Extruded aluminum (molded PA cover) |
| Dimensions |
61 x 77 x 61 mm (2,40 x 3 x 2,35 in) |
| Weight |
300 g/unit (1,4 lbs) |
| Battery type |
2 AAA batteries |
| Operating time |
20 hours continuous operation |
| Measuring distance |
50 mm - 6000 mm (6″ to 20 feet) |
| Measuring accuracy |
Better than 0,5 mm or 0,2 degrees (3,49 mils/in) |
| Pulley diameter range |
From 75 mm and larger - standard (3″ and larger) |
| Classification |
Class 2 laser |
| Pulley belt groove width |
6 mm - 40 mm (standard) |
| Output power |
< 1mW |
| Laser wave length |
630 - 675 nm |
* Specifications are subject to change without notice.
